acting load
英 [ˈæktɪŋ ləʊd]
美 [ˈæktɪŋ loʊd]
【化】加载
双语例句
- The optimum design example shows that the variation coefficient of load torque acting on cutting head is decreased 13.9%, and specific energy consumption is lowered 16.9%, which efficiently improves the load characteristic of cutting motor and increases the ratio of energy utilization.
优化设计实例表明，截割头的负载转矩变差系数减小了13.9%，截割比能耗降低了16.9%，有效改善了截割电机的负载特性，提高了能量利用率。 - The author recommends the design-calculation method for double acting pneumatic transmission system with constant load, this method fulfils its dynamic behaviour requirements.
介绍定负载双作用气压传动系统满足动特性要求的设计计算方法。 - The main content and achievements accomplished are as follows: ( 1) All the loads acting on a trestle were calculated. In addition, according to the practical conditions, load combination was proposed.
论文内容和成果主要包括以下几个方面：（1）进行了热力管道架空支架所受全部荷载计算，完成了荷载的计算方法和荷载组合。 - It also researches equivalent linear method of bilinear mode under the acting of simple harmonic load and earthquake load. It puts forward two-point equivalence method which is peak equivalent in earthquake.
文章还研究了双线型模型在简谐荷载和地震荷载作用下的等效线性化方法，同时提出了在地震作用下峰值等效的两点等效方法。 - A study on the stroking time of double acting pneumatic cylinders with constant load
恒定负载双作用气缸动作时间的研究 - The results of laboratory tests show as follows: The frictional resistance between angle steel and concrete is primarily acting on the front end under the same small load;
试验结果表明：在较小的同一荷栽作用下，角钢与混凝土间的摩擦力主要是由前端部分承受； - The paper analyzes the stress and deformation properties of the "culvert-soil structure" and the earth pressure acting on the culvert when the load reducing measure is putted into practice ( paving EPS or loose soil on the top of the culvert).
研究减荷措施下（涵项铺设一定厚度的聚苯乙烯泡沫、涵顶铺设疏松质土）涵洞受力特性和涵&土结构整体受力与变形特性。 - The mode of loads acting on the shield lining and load reduction factor are studied. ( 2) Force analysis of over-river shield tunnel lining structure.
研究了外荷载作用于盾构衬砌上的作用方式以及荷载折减系数。（2）越江盾构隧道衬砌结构受力分析。 - By the analysis of pick arrangement parameters influenced on the load acting on cutting head, the strategy is presented to depress the load fluctuation. And the mathematic model of optimal design for pick arrangement parameters based on minimum load fluctuation is built.
通过分析截齿排列参数对截割头载荷的影响，提出了降低载荷波动的策略，建立了基于载荷波动最小的截割头截齿排列参数优化设计数学模型。 - The wind load acting on the tower and the wave load acting on the transition section of bucket foundation will produce relatively large stress.
作用于塔架上的风荷载以及作用在筒型基础过渡段的波浪荷载会使塔架和筒型基础产生比较大的内力。